On most older openers they are labelled 1 2.
Konnected garage door relay.
Now if your activate the switch it triggers the relay as it s supposed to 500ms pulse and the door activates.
Connecting to the garage door.
The red one pictured above can be a high or low level relay.
Important notes for konnected and relays with the production boards you don t need a relay anymore for an alarm.
Out pin or any zone 1 5 goes to in on the relay.
I have the binary zones properly setup but when i go to setup the switchable outputs that are connected to the relays for garage door opening closing the konnected board opens the relays and won t close them.
If you want to test if they are the correct wires attach a wire each contact.
For instance for a garage door you just need to briefly close the circuit to actuate the garage door motor.
This should start the garage door movement.
A relay has two sides.
Make sure you change that setting in the thing configuration.
Most of the relays that we sell at konnected are low trigger relays.
There is dedicated 12v switch output for alarms.
If you want to use konnected to control a garage door opener sprinkler system or turn on off something that has a separate voltage source you use a relay module.
Konnected is a platform to take legacy wired security systems and turn them smart.
Power trigger side of the relay.
Briefly touch the wires together.
The gear in the top right corner of the things properties in the smartthings app.
Wire relay to board power connect the 5v on the board to vcc on relay female to female jumper ground connect gnd next to 5v on the board to the g on the relay female to female control connect pin to in on relay repeat if using multiple relays.
And most garage doors can be upgraded fairly easily.
One thing many of us use everyday are garage door openers.
Find the switched outputs for the garage door opener.
